2-14
Chapter 2: Getting started
The following two items appear only when you set the CPU Core Ratio to [Sync All
Cores] or [Per Core].
1-Core Ratio Limit [Auto]
Select [Auto] to apply the CPU default Turbo Ratio setting or manually assign a 1-Core
Limit value, which should be higher than or equal to the 2-Core Ratio Limit.
2-/3-/4-Core Ratio Limit [Auto]
These items become congurable only when you set the CPU Core Ratio item to [Per
Core].
2.5.4 Min CPU Cache Ratio [Auto]
Allows you to set the uncore ratio of the processor to its possible minimum value.
Conguration options: [Auto] [1] ~ [30].
2.5.5 Max CPU Cache Ratio [Auto]
Allows you to set the uncore ratio of the processor to its possible maximum value.
Conguration options: [Auto] [1] ~ [30].
2.5.6 CPU bus speed : DRAM speed ratio mode [Auto]
Allows you to set the CPU bus speed to DRAM speed ratio mode.
[Auto] DRAM speed is set to the optimized settings.
[100:133] The CPU bus speed to DRAM speed ratio is set to 100:133.
[100:100] The CPU bus speed to DRAM speed ratio is set to 100:100.
2.5.7 Memory Frequency [Auto]
Allows you to set the memory operating frequency. The conguration options vary with the
BCLK/PEG Frequency item settings.
Selecting a very high memory frequency may cause the system to become unstable! If this
happens, revert to the default setting.
2.5.8 CPU Graphics Max. Ratio [Auto]
Allows you to set the CPU Graphics maximum ratio. The maximum ratio is 60x. Use <+>/<->
to adjust the value.
2.5.9 GPU Boost [As is]
Allows you to enable the GPU Boost to accelerate the integrated GPU for extreme graphics
performance. Conguration options: [As is] [Enabled].
2.5.10 EPU Power Saving Mode [Auto]
Allows you to enable or disable the EPU power saving function. Conguration options:
[Disabled] [Enabled] [Auto]