Filter
Top Products
2-20 Chapter 2: Basic installation
2.10 Installingaoppydiskdrive
The Vintage2-PE2 system comes with one 3.25-inch drive bay for a oppy
disk drive.
To install a oppy disk drive:
1. Remove the drive slot metal plate cover.
2. Carefully insert the oppy disk drive into the oppy drive bay until the
screw holes align with the holes on the bay.
3. Secure the oppy disk drive with two screws on both sides.
4. Connect the oppy disk drive signal cable to the signal connector at
the back of the drive.
5. Connect the other end of the signal cable to the oppy disk drive
connector on the motherboard. See page 4-6 for the location of the
oppy disk drive connector.
6. Connect a 4-pin power cable from the power supply unit to the power
connector at the back of the oppy disk drive.
Floppy ribbon
cable
Power cable
3
3
2
3
3
2
remove the metal
plate cover and
install the card
reader module
here