Filter
Top Products
5-18
Chapter 5: Software support
5.6.4 Creating a RAID Volume
[
HELP
]
Enter a string between 1 and 16 characters in length taht can be used
to uniquely identify the RAID volume. This name is case sensitive and
can not contain special characters.
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[
CREATE ARRAY MENU
]
Name: RAID_Volume1
RAID Level: RAID0(Stripe)
Strip Size: 128KB
Capacity: 149.0GB
Create Volume
[ ]-Change
[ ]-Change
[TAB]-Next
[TAB]-Next
[ESC] Previous Menu
[ESC] Previous Menu
[Enter]-Select
[Enter]-Select
5.6.3 Creating, Deleting, and Resetting RAID Sets
The Serial ATA RAID set must be configured in the RAID Configuration
utility. This configuration can be done by the Intel
®
RAID Option ROM.
During the Power-On Self Test (POST), the following message will appear
for a few seconds: “Press <Ctrl-I> to enter Raid Configuration Utility”.
When this message appears, press <Ctrl+I> to launch the RAID
configuration utility.
[
DISK/VOLUME INFORMATION
]
RAID Volumes:
None defined.
Non-RAID Disks:
Port Drive Model Serial # Size Status Bootable
0 ST380013AS xxxxxxxx 74.5GB Normal Yes
1 ST380013AS xxxxxxxx 74.5GB Normal Yes
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[
MAIN MENU
]
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[ ]-Select
[ ]-Select
[ESC] Exit
[ESC] Exit
[Enter]-Select Menu
[Enter]-Select Menu
To create a RAID volume:
1. Select 1. Create RAID Volume and press <Enter> . The following
screen appears.