Filter
Top Products
2-302-30
2-302-30
2-30
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
3.3.
3.3.
3.
IDE RAID connectorsIDE RAID connectors
IDE RAID connectorsIDE RAID connectors
IDE RAID connectors
(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])
(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])
(40-1 pin PRI_RAID1 [red], SEC_RAID1 [red])
These connectors are for Ultra ATA 133/100/66 signal cables. These
connectors support up to four IDE hard disk drives that can be
configured as a disk array through the onboard IDE RAID controller.
• Before creating a RAID set using Ultra ATA hard disks, make
sure that you have connected the Ultra ATA signal cable and
installed Ultra ATA 133/100/66 hard disk drives.
• The system automatically assigns the boot sequence of ATAPI
devices connected to the IDE RAID connectors.
• The ITE
®
8212F controller supports a maximum of 2 Ultra ATA hard
disk drives. In RAID 1 array, set both drives either as Master or Slave
before configuring a RAID 1 set.
These connectors are set to IDE mode by default. In IDE mode, you can
connect IDE devices to these connectors such as boot/data hard disk
drives or optical drives. If you intend to create an IDE RAID set using
these connectors, set the
ITE8212F ControllerITE8212F Controller
ITE8212F ControllerITE8212F Controller
ITE8212F Controller item in the BIOS to
RAID Mode. See section “4.4.6 Onboard Devices Configuration” for
details.
P5GDC
P5GDC RAID connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
cable to PIN 1.
PRI_RAID1
PIN 1
SEC_RAID1