Asus Z77 Computer Hardware User Manual


 
ASUS SABERTOOTH Z77
2-21
Chapter 2
You can connect the front panel USB cable to the ASUS Q-Connector (USB, blue)
rst, and then install the Q-Connector (USB) to the USB connector onboard if your
chassis supports front panel USB ports.
Remove the USB dust cover before installation.
The USB 2.0 connector module is purchased separately.
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
6. USB 2.0 connectors (10-1 pin USB78, USB56, USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specication that supports up to
480 Mbps connection speed.
7. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s).
Connect the S/PDIF Out module cable to this connector, then install the module to a
slot opening at the back of the system chassis.
The S/PDIF module is purchased separately.