Asus Z7S WS Computer Hardware User Manual


 
ASUS Z7S WS 2-35
9. SSI power connectors (24-pin EATXPWR, 8-pin EATX12V, 4-pin ATX12V)
These connectors are for SSI power supply plugs. The power supply plugs
are designed to t these connectors in only one orientation. Find the proper
orientation and push down rmly until the connectors completely t.
Z7S WS
®
Z7S WS ATX power connectors
8-PIN
GND
+12V1
GND
+12V1
GND
+12V4
GND
+12V4
24-PIN Power Connector
EATXPWR
EATX12V
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
-5 Volts
+5 Volts
+3 Volts
-12V3
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12V3
+12V3
+3 Volts
+5 Volts
Ground
ATX12V
+12V2
GND
+12V2
GND
For a fully congured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specication 2.0 (or later version)
and provides a minimum power of 600 W.
Do not forget to connect the 8-pin EATX12V power plug; otherwise, the
system will not boot.
If you install only one CPU on the CPU0 socket, you can connect only the
EATXPWR and EATX12V power connectors to boot the system.
Use of a PSU with a higher power output is recommended when conguring
a system with more power-consuming devices. The system may become
unstable or may not boot up if the power is inadequate.
If you want to use two high-end PCI Express x16 cards, use a PSU with
600W power or above to ensure the system stability.
If you are uncertain about the minimum power supply requirement for your
system, refer to the
Recommended Power Supply Wattage Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.