Filter
Top Products
Wireless Broadband Router
9
OS, Windows 95/98/NT/2000/Me, etc. The product provides
a very easy and user-friendly interface for configuration.
Before Configuration
This section describes the configuration required by LAN-
attached PCs that communicate with the Wireless
Broadband Router, either to configure the device, or for
network access. These PCs must have an Ethernet interface
installed properly, be connected to the Wireless Broadband
Router either directly or through an external Switch, and
have TCP/IP installed and configured to obtain an IP
address through a DHCP server or a fixed IP address that
must be in the same subnet of the Wireless Broadband
Router. The default IP address of the Wireless Broadband
Router is 192.168.1.1 and subnet mask is 255.255.255.0.
The best and easy way is to configure the PC to get an IP
address from the Wireless Broadband Router (DHCP
client).
Please follow the steps below for PC’s network environment
installation. First of all, please check your PC’s network
components. The TCP/IP protocol stack and Ethernet
network adapter must be installed. If not, please refer to MS
Windows relative manuals.
Before you configure this Wireless Broadband Router, you
need to know the following default settings:
• Username:admin
•
Password:admin
• IP LAN address: (192.168.1.1), Subnet Mask
(255.255.255.0)
• IP WAN address:dhcp client
• DHCP Server: enable (192.168.1.100-192.168.1.199)
•
SSSID= default, Channel=6, WEP/WAP=disable