Filter
Top Products
4
www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
1. Connect transmitter module to the USB connection on a computer.
2. Connect mouse, keyboard, printer, scanner, phone or any other USB enabled device to the receiver mod-
ule.
3. Install or use pre-existing CAT5, 6 or 7 cable.
4. Make sure to use a cable tester to check all wires are correctly terminated. (Incorrect Termination may
cause damage to the receiver module).
CONNECTION AND OPERATION
TROUBLESHOOTING
No Connection or Signal is going in and Out:
a. Please test your RJ45 cables with a Fluke or similar tester to make sure that all the wires are connected and
the distance is within the limits.
b. If you are using patch panel or and RJ45 wall plates, the distance will be reduced, please do a direct
connection bypassing all additional equipment.
c. Please try to re-terminate your CAT5/6/7 wire to 568B.