Filter
Top Products
Introduction
1-2 ATAVRAUTO200 User Guide
7698A–AUTO–01/07
1.2 ATAVRAUTO200
features
The ATAVRAUTO200 provides the following features:
ATmega88 QFN32
AVR Studio
®
software interface
(1)
,
Power supply
– Regulated 5V
– From LIN connector (LIN network power supply)
JTAG connector:
– for on-chip In Situ Programming (ISP)
– for on-chip debugging using JTAG ICE
DC Motor connector
– DC Motor power supply output
– Hall effect sensor(s) power supply and input(s)
Serial interface:
– 1 LIN interface 1.3 and 2.0 compliant (firmware library available on the ATMEL
website for LIN 1.3).
On-board resources:
– 1 LIN transceiver with internal regulator
– Relay for DC motor control
– Shunt Resistor for motor current measurement
– Speed/Position measurement Inputs
– Power supply measurement
System clock:
– Internal RC oscillator
Dimension: 45 mm x 45 mm
Note: The ATmega88 is supported by AVR Studio, version 4.12 or higher. For up-to-
date information on this and other AVR tool products, please consult our web
site. The newest version of AVR Studio, AVR tools and this user guide can be
found in the AVR section of the Atmel web site, http://www.atmel.com.