Filter
Top Products
AT&T Plug&Share
™
Wireless PCI Adapter 22 Mbps Turbo 6500B4X 5
STEP 4: Configure the PCI adapter for your wireless network
To configure the PCI adapter for communication with your wireless network, use the Configuration
Wizard.To start the Configuration Wizard, double-click on the Utility icon (four vertical bars) next
to your computer’s time display.
Wizard screen 1
SSID: Enter the SSID (Service Set Identifier) used by your
wireless router or access point.The default SSID is at&t
.You
should change this to another name.The SSID is case sensitive
(i.e.,“cat” and “Cat” are not the same). All wireless adapters on
your network must use the same SSID as your wireless router
and/or access point
.
WEP: WEP is a form of encryption. If you click On to enable
encryption in your wireless adapter, you must turn on WEP in
your router, and make sure all devices use the same settings.
Click Apply to save your settings and display Wizard screen 2
(see next page).
CAUTION: SSID and all WEP settings must be identi-
cal in all wireless network devices. WEP
Ascii/Hex Key
must match the WEP settings used in your router (may
be called Security Phrase
, Hex Key or other term).
Enter up to 32
letters or numbers
ATT6500b4x-QSG-d06.qxd 10/17/2003 5:03 AM Page 5