Filter
Top Products
CONTROLLER REGISTRATION
6
5
CONTROLLER REGISTRATION:
1. When you purchased your AT&T Remote Monitor system, you created a remote account
with a UserID and Password. Using a web browser on a PC connected to the same
local network as your XG1000 Controller, go to site http://www.attrm.com and log in
using this ID and password.
2. After successfully logging in, select the Account Settings tab and then select Discovery.
3. To register your controller with the remote service site, press the ‘NEW LOCATION’ button.
A plug-in will be downloaded from http://www.attrm.com that enables the browser to detect
and communicate with the controller. A pop-up will be shown that will guide you through
the process. If the software detects any problems with downloading or running the plug-in,
an error message will be displayed that will link to help information. The most common cause
for problems is security settings in your web browser that do not allow the required operations.
4. When the controller registration has completed, you will see a confirmation message as
in the following picture. After you successfully register your controller you may be prompted to
follow instructions in order to improve performance.
5. After the controller has been successfully installed and registered, it will automatically start
device discovery. If you don’t see a message that discovery is initializing or in progress, press
the ‘START DISCOVERY’ button. Any cameras that are detected will be registered automatically.
Any other wireless devices need to be registered one at a time. You can do this now or you can
register the additional devices later. To do this, examine the documentation that came with the
device and locate the discovery button on the device. It is usually in a small hole in the case.
Wait until one device is finished registering before you press the discovery button on the next device.
When you are done, press the ‘STOP DISCOVERY’ button.
6. Select the Device Overview tab and verify that all of your devices are shown.
DEVICE DISCOVERY ///
YOU CAN ADD DEVICES ANY TIME BY USING THE FOLLOWING PROCEDURE:
1. Select the Account Settings tab and then select Discovery.
2. Press the ‘START DISCOVERY’ button and wait until you get a message indicating
discovery is in progress.
3. Cameras should be detected and registered automatically. If you receive a message
that the camera needs to be reset, press the Factory Defaults button on the camera.
4. For wireless devices, press the Discover button on each device, one at a time
and wait until the device is registered before proceeding to the next one.
5. When you are finished adding devices, press the ‘STOP DISCOVERY’ button.
Go to the Device Overview page and make sure that all of the devices appear in the list
YOU CAN ALSO DELETE DEVICES AT ANY TIME:
1. Select the Account Settings tab and then select Discovery.
2. Press the ‘DELETE’ button next to the device that you would like to remove.
3. Confirm that you want the device to be deleted.
4. Go to the Device Overview tab and confirm that the device no longer appears in the device list.