ATTO Technology 1500E Network Router User Manual


 
IP Storage
Rev 1, 9/04
Gigabit Ethernet and SCSI
GbE Interface:
10/100/1000 GbE RJ45 Ethernet port
Supports IP v.4
Supports iSCSI Protocol 1.0
Compliance with IEEE 802.3ab GbE
Compliance with IEEE 802.3x Flow Control
SNMP MIB 2 support
Supports Jumbo Ethernet frame
SCSI Interface:
Single 68-pin SCSI connector
Ultra160 LVD SCSI – 160 MB/sec.
maximum throughput
Backward compatible with all single-ended
SCSI devices
Supports SCSI-3 specifications
Management
Operating Environment:
Operating system independent
Supports all SCSI devices including hard
disk drives, tape drives, RAID controllers,
DVD, MO and CD libraries
•Multiple interface orientations available -
Ethernet and RS232 ports can be located
on either the long edge or short edge of
the board (see Figure 2 and 3)
Local and Network Management:
ExpressNAV™ integrated management
console for remote configuration,
management and diagnostic capabilities
Command line management access via
Ethernet and RS232
Local diagnostics supported through
SNMP, Telnet, and FTP
•Includes support for DHCP, ICMP, and RMON
Built in memory has ECC detection and
correction
•User accessible reset switch
Built in watchdog timer
•Automatically detects and maps all
connected devices at power on
ATTO iPBridge
1500E
Environmental and Physical
Characteristics
Configurations:
Embedded Board
Dimensions:
Embedded Board:
4.4” W X 6.4” L
Operating Environment:
Operating Temperature: 5-40º Celsius
Power: Standard 4pin power connector, 12V, 1.5A
Nominal power consumption: 1A @ 12V
Weight: 1.5 lbs
Figure 1 – iPBridge 1500E Board Detail
Figure 2 – iPBridge 1500E Standard
Embedded Configuration
Figure 3 – iPBridge 1500E Optional
Desktop Configuration