ATTO Technology 3100 Network Router User Manual


 
22
4.10 Save/Restore panel
This panel saves the new configuration changes in FibreBridge NVRAM, restores values to the factory
defaults, or exits without saving the changes.
CAUTION
New settings and newly flashed firmware will
not take affect until the FibreBridge power is cycled.
Leave This Session
Closes the current connection with the FibreBridge and
exits BridgeTools. Changed parameters during this session
will not take effect unless they were saved before closing the
connection.
Make Use of Saved Changes
Issues a restart firmware command to the FibreBridge. This
is the same as cycling power on the FibreBridge. Any
freshly saved configuration parameters or new firmware
will now be in effect.
Save Current Settings
Saves any changes made to the configuration parameters.
The FibreBridge will use these options the next time it is
powered up.
Set to Factory Defaults
Sets configuration settings to the factory defaults.
Undo Changes
Ignores any changes made since entering the BridgeTools
program and returns configurations to the last saved values.
Some options will be “grayed out” on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other
selections. The chart below shows options available based on model and access method.
Model/access method
Options
2200/3200
in-band
2200/3200
Ethernet
2200/3200
serial port
4500
in-band
4500
Ethernet
4500
serial port
Leave this session
●●●●●●
Make use of saved changes
●● ●●
Save current settings
●●●●●●
Set to factory defaults
●●●●●●
Undo changes
●●●●●●