Filter
Top Products
45
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
ZoneClearAll
Removes all entries from the Planned Zone
Configuration.Removes any active zones if followed
immediately by a ZoneCommit command.
Set syntax: ZoneClearAll
ZoneCommit
Commits the current Planned Zone Configuration,
making it the persistent, Active configuration. To
complete this procedure, the ZoneState command must be
entered as enabled to activate the zone before using the
ZoneCommit command.
Set syntax: ZoneCommit
ZoneCreate
Creates a new named zone. Names may be up to 16
characters.To complete this procedure, the ZoneState
command must be entered as enabled to activate the zone
before using the ZoneCommit command (which makes
the Planned Zone Configuration the Active
configuration).
Set syntax: ZoneCreate zone_name
ZoneDelete
Deletes one or more named zones. To complete this
procedure, the ZoneState command must be entered as
enabled to activate the zone before using the
ZoneCommit command (which makes the Planned Zone
Configuration the Active configuration).
Set syntax: ZoneDelete [zone_name...]
ZoneInfo
Displays the named zones’ definitions. Information about
the Active Zone Configuration is the default; if you want
information about the Planned Zone Configuration, type
ZoneInfo Planned zone_name.
Get syntax: ZoneInfo
ZoneRemoveDevice
Removes one or more LUNs (devices) from an existing
zone. To complete this procedure, the ZoneState
command must be entered as enabled to activate the zone
before using the ZoneCommit command (which makes
the Planned Zone Configuration the Active
configuration).
Set syntax: ZoneRemoveDevice [zone_name]
[device_LUN...]
ZoneRemoveHost
Removes one or more hosts from an existing zone. To
complete this procedure, the ZoneState command must be
entered as enabled to activate the zone before using the
ZoneCommit command (which makes the Planned Zone
Configuration the Active configuration).
Set syntax: ZoneAddHost [zone_name] [host_name...]
ZoneRemovePort
Removes one or more ports [port_name] from an existing
zone. The port refers to the specific HIC, either 0 or 1. To
complete this procedure, the ZoneState command must be
entered as enabled to activate the zone before using the
ZoneCommit command (which makes the Planned Zone
Configuration the Active configuration).
Set syntax: ZoneAddPort [zone_name] [0|1]
ZoneRetrieve
Retrieves the Active Zone Configuration into the Planned
Zone Configuration to allow modifications of the current
configuration.
Get syntax: ZoneRetrieve
ZoneState
Changes the specific state of a zone. The ZoneState
command must be entered as enabled to activate the zone
before using the ZoneCommit command (which makes
the Planned Zone Configuration the Active
configuration).
Default: disabled
Set syntax: ZoneState zone_name [enabled|disabled]
Get syntax: ZoneInfo
Information: DriveCopyStatus