Filter
Top Products
11-12 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter
12. Click Apply to save the changes or Cancel to ignore the
changes
Using the CLI To modify an OSPF interface using the CLI, enter the following
command:
>(configure router ospf)# network <ip-address>
<wildcard-mask><area-id>
* Note: If you use the network area CLI command to add an
interface to an OSPF area, be careful not to enter the IP
mask for the <wildcard-mask> variable.
The <wildcard-mask> variable is the inverse of a network
mask. Enter a 32-bit number in four-part, dotted
decimal format. Place ones in the bit positions that you
want to mask.
For example, to enable OSPF on interface 10.10.10.1
(where the network mask is 255.255.255.0) and assign it
to area 2.2.2.2, enter:
network 10.10.10.1 0.0.0.255 area 2.2.2.2
If you enter the IP network mask (255.255.255.0)
instead of the wildcard mask (0.0.0.255), all OSPF
interfaces that have 1 for the last octet of their IP address
will be added to area 2.2.2.2.
MD5 Key ID Enter the MD5 authentication key ID as a decimal value. The value
range is 1- 255.
Interface State Select the interface state. The available sites are:
• Normal (default)
• Passive
Table 6-55. OSPF Interface Dialog Box Parameters continued
Parameter Definition