Filter
Top Products
2-32 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter 2
Changing the Console Serial Port Settings
You can change the communications settings for the serial port
connection located on the front panel of the layer 3 supervisor
module from the Web Agent. The switch’s console port is initially
configured as a TTY Console to support a TTY connection. The layer
2 and layer 3 supervisor modules allow you to reconfigure the
console serial port as a PPP Console to support a dial-in PPP
connection using a modem.
* Note: If you reconfigure the serial port as a PPP console, you
can only change the switch’s baud rate and flow control
parameters. The flow control parameters are limited to
None or Xon/Xoff.
Configuring the Serial Console Port as a TTY Console
You can configure the serial port as a TTY console using either the
Web Agent or the CLI.
Configuring the
Serial Console
Port as a TTY
Console Using
the Web Agent
To configure the console serial port as a TTY Console using the Web
Agent:
1. Select Console Configuration from the System>
Configuration group on the Web Agent. The Console
Configuration window opens (Figure 2-16).