Filter
Top Products
4-30
Chapter 4
Cajun P550/P880/P882 Switch User Guide
Adding Ports to a Hunt Group
You can add ports as needed after you create a hunt group. You can
add ports using either the web agent or the CLI.
Adding Ports to
a Hunt Group
Using the Web
Agent
To add ports to a hunt group using the web agent:
1. Select Configuration from the Modules and Ports group on
the Web Agent window. The Module Information dialog box
opens (Figure4-16).
2. Select a port number from the Ports column. The Physical
Port Configuration dialog box opens (Figure4-17).
3. Select a checkbox for a specific port from the Enable column.
This disables that port. The checkmark disappears and the
port is disabled.
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
5. Select Modules at the bottom of the Physical Port
Configuration dialog box. The Module Information dialog box
re-opens.
6. Select a number from the Switch Ports column for the
module whose port(s) you are adding to the hunt group. The
Switch Ports dialog box opens (Figure4-21).
Figure 4-21. Switch Ports Dialog Box