Filter
Top Products
NetWare
UNIX
Windows
OS/2
Macintosh
AXIS 5400 User’s Manual Section 3: Basic Installation
17
Connecting a printer to the Ethernet Network
Follow the instructions below to connect a printer to the network via
the AXIS 5400 print server.
Caution! ❏ The AXIS 5400 external power supply you are using must be
marked with the correct voltage! Refer to Package Contents, on
page 12.
1. Make sure that the printer is switched off and that the AXIS 5400
external power supply is disconnected.
2. Locate the serial number, found on the underside label of the
AXIS 5400, and write it down. You will need this number later
during the network configuration.
3. Connect the AXIS 5400 to the printer, either directly to the
parallel printer port, or using the optional printer cable extension
with the optional velcro ribbons.
4. Connect your AXIS 5400 to the network using a twisted pair
category 5 cable (10baseT and 100baseTX).
5. Switch on the printer and connect the external power supply to
the AXIS 5400. The power indicator lights. If the network
indicator starts to flash, the AXIS 5400 is successfully connected
to the network.
6. Press and release the test button on the AXIS 5400 to print a test
page. If the printer and the AXIS 5400 are correctly connected,
the AXIS 5400 internal test page will be printed.
You are now ready to install your server onto your network using one
of the methods detailed in the Installation Guide, on page 19.
5400