Filter
Top Products
The unit will remain in configuration mode for ten
seconds. During that time, pressing the front-panel
button will change the default setting for the
brightness of the status LED as noted below:
One press – Low brightness
Two presses – Medium brightness
Three presses – High brightness
After the ten-second configuration period has
elapsed, the status LED will revert to green
(”Standby” mode).
If no button presses are detected during the ten
second period, the unit will revert to the factory
default setting (high brightness).
Changes to the default settings will also be
transmitted via the AyreLink communication
system to other linked components. Therefore,
changing the display brightness of the Ayre 3-Phase
Power Supply will make the same change on all
linked components.
Configuring an AyreLink System
When any AyreLink source component is changed
to the “Operate” mode, it broadcasts that
information to the other linked components. Part of
the transmitted information is an alphabetical code
that identifies the source of the broadcast. The
3-Phase Power Supply will transmit the identifier
code “P”. This information can be used by other
linked components to automate operation of the
system.
11