Banner DX81P6 Power Supply User Manual


  Open as PDF
of 4
 
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
2 P/N 131628 rev. B
SureCross™ DX81P6 FlexPower™ Supply Module
5-pin M12 Quick Disconnect Pinout
3 Blue dc common (GND)
5 Gray 3.6 to 5.5V dc
Hookup Diagram
Only SureCross™ FlexPower™ DX80
devices may be powered from this supply.
Battery Replacement
Battery Replacement
To replace the lithium “D” cell battery pack in the DX81P6 FlexPower™ battery kit,
Remove the four screws mounting the clear plastic battery pack cover to the housing.
Remove the cover and foam spacer.
Disconnect the discharged battery pack.
Remove the discharged battery pack and replace with a new battery pack. Caution:
There is an explosion risk if the battery pack is replaced with an incorrect type.
After replacing the battery pack, allow up to 60 seconds for the device to power up.
Properly dispose of the used battery packs according to local regulations by taking it to a
hazardous waste collection site, an e-waste disposal center, or any other facility qualified to
accept lithium batteries.
As with all batteries, these are a fire, explosion, and severe burn hazard. Do not burn or
expose them to high temperatures. Do not recharge, crush, disassemble, or expose the
contents to water.
Replacement battery pack model number: BWA-BATT-002. For pricing and availability, contact
Banner Engineering.
1.
2.
3.
4.
5.
 previous next