Filter
Top Products
D-Fly – Programming Guide v1.5 - 11 -
Data Capture
for Workforce
in Motion
1.4.3. No Data Loss mode - Disable “ACK” beep
Forces the scanner in Real Time mode (without data acknowledgement); Erases all captured data stored in
memory. The scanner should have been previously set in the “No data loss mode” ON (So scan the “Enable Real
Time with No Data Loss mode” barcode before).
Dis
able
ACK beep
1.4.4. Real Time - Buffered data option
It’s possible to set the scanner in “Real Time with No Data Loss mode” but with no bufferisation (buffer
configured to 0) when it’s not connected. In this particular situation the trigger will not activate the beam: so
impossible to read barcodes in this mode, and Both LEDs blinks orange.
1.5. The different connection methods
There are two (2) different way to create a connection from a Host and a scanner:
- Slave mode (by default)
The Host (PC, BaracodaManager, …) is creating the connection onto the scanner.
- Master mode
The scanner is creating itself a connection to the recorded Host Bluetooth address. This connection
attempt is set after a scan of barcode. The configuration of Host address (on which the scanner will set
up a connection) can be done:
o Via BaracodaManager software.
o Via scan of barcodes.
All usage mode (Real Time, No Data Loss, Batch) are obviously available on those two different ways of
connection.
The configuration of the Host Bluetooth address (BDA) is made by scanning the 0-9, a-f, A-F labels (Appendix 1)
as on a calculator; following the timestamp format shown above.
Max Buf f er ed Bar codes = 0
Max Buf f er ed Bar codes = MAX
\ VT\ VT Z\ NUL \ SOH\ SOH\ FF \ FF
Enabl e mast er mode
\ VT\ VT Z\ NUL \ SOH\ NUL \ F F\ FF
Di sabl e mast er mode
\ VT\ VTZ\ NUL\ STX\ SOH\ SOH\ FF\ FF
Enabl e mast er mode and di sconnect
\ VT\ VTZ\ NUL\ STX\ NUL\ SOH\ FF\ FF
Di sabl e mast er mode and di sconnect