Filter
Top Products
RoadRunners Evolution –L (1D) & -LA (Laser) – Programming Guide v1.3 - 13 -
Data Capture
for Workforce
in Motion
1.5. The different connection methods
There are two (2) different way to create a connection from a Host and a scanner:
- Slave mode (by default)
The Host (PC, BaracodaManager, …) is creating the connection onto the scanner.
- Master mode
The scanner is creating itself a connection to the recorded Host Bluetooth address. This connection
attempt is set after a scan of barcode. The configuration of Host address (on which the scanner will set
up a connection) can be done:
o Via BaracodaManager software.
o Via scan of barcodes.
All usage mode (Real Time, No Data Loss, Batch) are obviously available on those two different ways of
connection.
The configuration of the Host Bluetooth address (BDA) is made by scanning the 0-9, a-f, A-F labels (Appendix 1)
as on a calculator; following the timestamp format shown above.
For example: to set the following BDA: 00:c3:EF:44:a2:B9, the user will scan:
- “Set Remote BDA” label,
- “0” label,
- “0” label,
- “c” label,
- “3” label,
- “E” label,
- “F” label,
- “4” label,
- “4” label,
- “a” label,
- “2” label,
- “B” label,
- “9” label,
- “End of Config” label.
\ V T\ VT Z \ N U L \ S O H\ SO H \ F F \ F F
Enable master mode
\ V T\ VT Z \ N U L \ S O H\ NU L \ F F \ F F
Disable master mode
\VT\VTZ\NUL\STX\SOH\SOH\FF\FF
Enable master mode and disconnect
\VT\VTZ\NUL\STX\NUL\SOH\FF\FF
Disable master mode and disconnect
\ V T\ V T ^ \ N UL \S O H \ E N Q \ LF \ L F
Set Remote BDA
\ L F \ L F E N D \ F F \ F F
End of Config