Filter
Top Products
Connections
3-1
5975007 BARCOGRAPHICS 808S 051196
3
CONNECTIONS
PORT 4/5
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
75 Ohm
PORT 2
75 Ohm
This device complies with part 15 of
th e FCC ru les. Op erati on is su bj ect to
follo wing two conditio ns (1). This
device may not cause harmful i nter-
ference, and (2) this device must
accept any in terference received
including interference that may cause
undesired operation"
120/23 0 V
7/5 A mp
50/60 Hz
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector at the backside of the projector.
Power Check
Power voltage indication on sticker on the back side of the projector.
The power voltage is indicated by the art. no.
Warning !
Check if the indicated power voltage corresponds to that of the wall
outlet.
Art. No. R9000901 must be connected to a 230 VAC power source.
Art. No. R9000908 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch must be
set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector switched off
green color : projector in Operational mode
red color : projector is in Standby mode.
VIDEO
green : operation
red : standby
PORT 1
OFF - ON
75 Ohm
PROJECTOR MODE
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
RS232 IN
RS232 OUT IR
REMOTE
RS232 INRS232 OUTIR
REMOTE