Filter
Top Products
Connections
3-4 5975007 BARCOGRAPHICS 808S 051196
Connecting a RGB Analog source to port 3.
Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Barco interfaces which can be applied :
Universal analog interface R9826100
RGB 120 MHz analog interfaceR9826570
VGA interface 120V R9828079
230V R9828070
MAC interface 120V R9828059
230V R9828050
MAGIK interface 120V R9828129 & R9828128
230V R9828120 & R9828121
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
with the RCU or build in RCU, press digit button 3.
PORT 4/5
See install ation instructions b efore c onnecting to the supply.
Voir la notice d'installation avant de raccorder au rés eau.
120/230 V
7/5 Amp
50/60 Hz
75 Ohm
PORT 2
75 Ohm
INP INP
R
G
BH
V
INPUT
ANALOG INTERF. 120MHz
ON
OFF
inver.
75 ohm term.
361
This d evice complies wit h part 15 o f
the FCC rules. Oper ation is su bject to
following two conditions (1). This
device may not cause harmfu l inter-
feren ce, and (2) t his d evice must
accept any in terfer ence received
includin g int erference that may cause
undesired operation"
Connecting a RGB Analog source to port 4/5.
RGB analog input terminals with separate H and V sync inputs, with
composite sync input or with sync signals on green (automatic sync
detection).
Always use an interface when a computer and local monitor have to
be connected to the projector. See 'Connecting a RGB Analog
source to port 3' for a list of BARCO interfaces which can be applied.
PORT 4/5
See installa tion ins tructions before connec ting to the sup ply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
75 Ohm
PORT 2
75 Ohm
INP
INP
R
G
B
H
V
INPUT
ANALOG INTERF. 120MHz
ON
OFF
inver.
75 ohm term.
363
This d evice compl ies wit h par t 15 of
the F CC ru les. Operati on is su bject t o
following two conditions (1). This
device may n ot cause h armfu l int er-
feren ce, and ( 2) t his d evice must
accept an y inter fer ence received
includ ing i nterf erence that may cause
undesired operation"
RGB input selection :
(RGB : R, G, B signals with automatic sync detection)
with the RCU or the build in RCU : press digit
button 4 or 5