Filter
Top Products
6. SwitchingOfftheD-CinePremiereDP100
6. SWITCHING OFF THE D-CINE PREMIERE DP100
Procedure for switching off the projector
• Close the dowser.
• Switch off the lamp
• Switch off the projector
6.1 Stop Image Projection
How to stop image projection
1. Press the dowser button (B). (image 6-1)
The dowser shuts, indicated by the built-in Red LED ON (B1).
2. Press the lamp ignition butt on (A) (image 6-1).
The lamp turns off, indicated by the built-in Red LED ON (A1).
A
A
2
A
1
B
2
B
1
B
D
Image 6-1
Bulb and Dowser switching off
6.2 Powering off the projector
CAUTION: To ensure maximum bulb life, first allow the lamphouse blower and the exhaust system run for at
least ten minutes after extinguishing the b
ulb, and then power off the projector.
How to power off the projector
1. Press the tumbler switch (A) in the “O ” position (OFF state) (image 6-2)
All parts of the projector have been powered off.
2. If the projector will not be used for a long pe
riod, pull out the power connector from wall outlet.
R5976907 D-CINE PREMIERE DP100 02/11/2005
21