Filter
Top Products
21
1
2
3
4
5
6
7
8
section
Firmware-Upgrade Guide
Connect your KVM Switch to the Mac Host
Step 5.
Press the first front-panel button on the KVM Switch until you hear three
beeps.NowtheKVMSwitchhasenteredintotheupgrademode.
Step 6.
Check to make sure the KVM cables from port 1 are connected to the
Mac host.
Note: A special upgrade cable is not needed to perform the upgrade since you
can use the same KVM cable that you use for connecting to the computers.
However, depending on the different models, the KVM cables you use
will vary.