Belkin F5U011 Network Card User Manual


 
You replaced the Ethernet Adapter with a new
Ethernet Adapter and it does not work.
The installation procedure produces the
message: Hardware and software support for
USB was not found.
The LED is off.
The LED is blinking.
You require additional information about
adding or removing network drivers.
The system does not respond when connecting
the Adapter (for example, the hourglass cursor
remains on the screen).
Each Belkin USB Ethernet Adapter has a
unique encoded Ethernet identifier. Unplugging
the adapter from the Windows
®
machine, and
plugging a different adapter into the same port,
will cause a problem in the protocol software.
The original device should first be completely
uninstalled.
The program detected that your computer is not
configured for proper USB support. There are
four main conditions to check:
1. You do not have a USB connection on the
motherboard. The solution is to upgrade your
motherboard or add a USB controller card.
2. It is possible that you do have the proper OS,
but there is no connection between the
motherboard and the USB connectors on the
bracket.
3. It is possible that you do have the proper OS,
but the controller on the motherboard is
malfunctioning.
There are two main possibilities:
1. The host computer might be in standby mode,
and not supplying full power to its devices.
2. The Ethernet Adapter did not properly
enumerate. Enumerate is a USB term meaning
the system has identified and configured the
device and given it a unique address.
The Ethernet port connection might be
inoperable. Check the Ethernet connection.
Replace the Ethernet cable.
Consult the appropriate Windows
®
98
documentation, or contact your System
Administrator.
Remove and reinstall the USB support
component of the operating system.
9