Filter
Top Products
5
En
INSTALLATION
Important Note: Please do not connect any USB devices to the Hub until
instructed to do so in step 4 of this installation
procedure.
1. Plug the AC adapter into a wall outlet or surge suppressor. Plug the
DC connector into the DC power jack found on the rear of the Hub.
Note: The Hub may be used without the power supply with most USB
devices
2. Plug the flat end (USB-A connector) of the provided USB device cable
into the downstream port of your computer or downstream port of
another hub. Plug the square end (USB-B connector) into the USB-B
connector on the back of the Hub.
Important Note: The Hub must be connected to a USB 2.0-compliant host
in order to function in high-speed mode (480Mbps data
rate). If the Hub is connected to a USB 1.1-compliant
host, it will operate only in low-speed or full-speed mode
(1.5Mbps/12Mbps).
3. Windows will now detect your Hub and install the required driver
support. (The Windows “Install New Hardware Wizard” may prompt
you to provide your Windows Installation CD to complete the driver
installation process).
P74395ea_F5U231ea_uk 05-09-2003 14:51 Page 5