Filter
Top Products
4
4
1
2
3
IMPORTANT NOTE: Please do not connect any USB devices
to the Hub until instructed to do so in step 6 of this installation
procedure.
1. Insert the Hub into the hole in the desk.
2. From underneath the desk, capture the Hub through the mounting
ring and while holding the Hub in place, twist the ring clockwise to
tighten the grip on the desk.
3. Once the Hub is secure, plug the included power adapter into a
wall outlet or surge protector and the other end into the rear of
the Hub.
4. Plug the flat end of the USB device cable into the downstream
port of your computer or another hub, and connect the square end
into the base of the Hub.
5. If your computer is on, your operating system will automatically
detect the Hub and load the corresponding drivers.
6. You can now plug in your USB devices to the Hub.
Note: You can use the Hub without the power supply when
connecting low-power devices such as keyboards and mice.
Important Note: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed mode (480Mbps
data rate). If the Hub is connected to a USB 1.1-compliant host, it will
operate only in low- or full-speed mode (1.5Mbps/12Mbps). When the
Hub is connected to a USB 1.1 host controller, the maximum USB
1.1 bandwidth of 12Mbps must be shared by all four ports.
Installation