Filter
Top Products
4
Hardware Installation
1. Remove the connector cover from the rear of the Hub
exposing the connector bay.
2. Plug AC adapter into 110V AC outlet, then plug the
adapter cord into the Belkin FireWire Hub.
Note: The amber LED at the top of the LED display will
illuminate indicating the Hub is in self-powered
mode.
3. Connect the Belkin FireWire Hub to an available FireWire
port on your computer using the provided 6-pin to 6-pin
FireWire cable.
Note: When a self-powered FireWire device is connected to
the Hub, the Amber-colored LED will extinguish, and
the Green-colored LED will illuminate.
4. Connect your FireWire devices to the Hub using the
FireWire cables supplied with each device. If your device
did not include a cable, or the cable has been lost, please
visit the Belkin website @ belkin.com, or your local retailer
to obtain a quality Belkin replacement cable.
5. Replace the Connector Bay cover.
6. Install the Hub stand. To install the stand simply squeeze
the legs of the stand together and insert the circular
portion of the stand into the female docking ring on the
right side of the Hub.
7. Place the Hub in a convenient location on your desktop.
The Hub is now ready for use.
Note: To use the Belkin 6-port FireWire Hub, your computer
must feature a built-in FireWire Host Adapter, or be
equipped with a FireWire Host adapter upgrade card.
Make sure your host adapter is properly installed and
recognized by your operating system before installing
the Hub.
Hardware Installation Cont.
5
En
P73615-F5U526-AM-Man 4/26/01 12:43 PM Page 4