Filter
Top Products
Extension Unit
4.Plug the extension unit into an AC electrical outlet near where you want a new phone jack.
5.Plug telephone’s line cord into the extension unit.
6.Please note: Installation is not complete until you perform the steps outlined in the Security
Programming directions below. Once this is done, you will be able to hear a dial tone on
your phone.
Wall Outlet
Extension Unit
Security Programming
The base and extension units are now connected to your telephone system. After completing
steps 1-5 in the installation sequence above, set up security for both units by following the easy
steps below.
1.Using a small pointed object, such as a pen or pencil tip, press the black recessed button on
the side of the base unit. The green light on the front of the base unit will come on and stay
lit during the security programming sequence.
Note: Once the button is pressed, you must program the extension unit within five minutes.
If the five-minute time limit is exceeded, the light on the base unit will go out and the
programming procedure must be restarted by once again pressing the button on the
base station.
Base Unit
Green Light
2.Using the same small pointed object, press the black recessed button on the side of the
extension unit. The green light on the front of the extension unit will flash once. This is
your notification that the security programming for this extension is complete. To program
additional extensions to the same base, repeat step 2 with the additional extensions.
Note: When the button is pushed on the extension, the light on the extension should come on for a
few seconds, and then go out. This indicates that the unit is operating properly. If the green
light is flashing repeatedly, your base unit is not in programming mode. You will need to
return to step 1 and repeat the steps.
Extension Unit
Green Light
3.Once all extensions have been programmed, you will need to verify the dial tone for each
phone. Take your phone off the hook and listen: you should hear a dial tone.
4