Belkin P73473 F5U006-UNV Computer Hardware User Manual


 
Installing the Belkin 4-Port USB PCI Card
2
1. POWER OFF THE COMPUTER AND DISCONNECT THE
POWER CORD.
2. Remove the screws that secure the computer cover and
remove the cover.
3. Touch any metal part of the case to ground yourself.
This will discharge any static electricity that could damage
your computer.
4. Locate an empty PCI expansion slot.
5. Confirm that the 4-Port USB PCI Card will fit into the slot
you have chosen.
6. Remove the port cover from the back of the PC which
corresponds to the PCI slot you selected. If there is a screw,
place it in a safe spot as you will be using it to attach the
4-Port USB PCI Card.
7. Push the 4-Port USB PCI Card firmly into the slot. Apply
pressure as needed until the edge connector is fully seated.
8. Now secure the 4-Port USB PCI Card with the screw that
you previously placed in a safe place.
9. Replace the computer’s cover.
10. Now that the 4-Port USB PCI Card is installed, you can
replace the power cable. Proceed to the next section,
“Installing the Software Drivers.”
P73473-F5U006-UNV-EU-man.qxd 30-06-2003 09:08 Page 2