Filter
Top Products
12
Configuring the SnapNType Software
To access the SnapNType application (see Fig. 6), tap “Start”,
and then “SnapNType” on your iPAQ.
Enable—this will allow the SnapNType to accept key input.
Disable—this will turn off the SnapNType.
Repeat Rate—this will determine the repeat frequency of a key
when you hold it down continuously.
Delay Until Repeat—this will determine the delay from your
holding down a key to the key repeating.
Fig. 6. SnapNType configuration screen
P73990-F8Q1502-MAN.QXD 5/23/02 1:27 PM Page 12