Filter
Top Products
Operation 23
Operation
Start up
1. Plug the power cord into the projector and
into a wall socket. Turn on the wall socket
switch (where fitted). Check that the Power
indicator on the projector lights orange after
power has been applied..
2. Remove the lens cap. If it is left on, it could
become deformed due to the heat produced by the
projector lamp.
3. Press and hold (for 2 seconds) Power
on the projector or remote control to start
the projector. As soon as the lamp lights
up, a "Power On Tone" will be heard. The
Power indicator light flashes green and
stays green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to
adjust the image clearness.
• If you don't want to activate Power on/off tone, you can enter the OSD menu to disable this
function. See "Mute (off)" on page 40 for details.
• If the projector is still hot from previous activity, it will run the cooling fan for
approximately 90 seconds before energizing the lamp.
4. If you are prompted for a password, press the arrow buttons to enter a four digit
password. See "Utilizing the password function" on page 24 for details.
5. Switch on all of the connected equipment.
The projector will start to search for input signals. The current input source being
scanned displays in the center of the screen. The searching message will continue
displaying until an input source signal is found.
You ca n press SOURCE on the projector or remote control to select your desired input
signal. See "Switching input signal" on page 26 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen.