Filter
Top Products
Operation 45
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu display time in the SYSTEM SETUP: Advanced > Menu Settings menu
sets the length of time the OSD will remain active after your last key press. The time
length ranges from 5 to 30 seconds in 5-second increments. Use / to select a
suitable time frame.
• Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu sets
the OSD position in five locations. Use / to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
OSD menus. Use / to select your language.
• Reminder Message in the SYSTEM SETUP: Advanced > Menu Settings menu
sets whether to display reminder messages on screen. Use / to select your
desired setting.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen
to be displayed during projector start-up. Use / to select a screen.
Select the lamp saver mode
• Using the remote control.
Press Smart Eco and Highlight Lamp mode and press / to select Normal/
Economic/Smart Eco.
•Using the OSD menu.
1. Press Menu/Exit and then press /
until the SYSTEM SETUP: Advanced
menu is highlighted.
2. Press to highlight Lamp mode and press
Mode/Enter. The Lamp Settings page
displays.
3. Highlight Lamp mode and press / to select Normal/Economic/Smart
Eco. The lamp brightness vary from the different lamp mode,see the description list
in table below.
If the Economic mode is selected, the light output will be reduced and result in darker projected
pictures.
Lamp mode
Description
Normal 100% lamp brightness.
Economic 80% lamp power consumption.
Smart Eco
This is default setting. Lamp power consumption will save from 30% to
100% dynamically by detecting the content brightness level.
Downloaded from www.Manualslib.com manuals search engine