Filter
Top Products
Maintenance50
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to
replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
Go to http://lamp.benq.com for a replacement lamp.
The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too hot.
Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after
turning the power back on, please contact your dealer. See "Indicators" on page 54 for details.
The following Lamp warning displays will remind you to change the lamp.
"XXXX" shown in the above messages are numbers that vary depending on different models.
Status Message
Install a new lamp for optimal performance. If the
projector is normally run with Economic
selected (See "Getting to know the lamp hour" on
page 49), you may continue to operate the
projector until the next hour lamp warning
appears.
Press MODE/ENTER to dismiss the message.
It is strongly recommended that you replace the
lamp at this age. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished.
Press MODE/ENTER to dismiss the message.
The lamp MUST be replaced before the projector
will operate normally.
Press MODE/ENTER to dismiss the message.
OK
Order Replacement Lamp
Lamp>XXXX Hours
Order a new lamp at lamp.benq.com
Notice
OK
Notice
Replace Lamp Soon
Lamp>XXXX Hours
Order a new lamp at lamp.benq.com
OK
Notice
Replace Lamp Now
Lamp>XXXX Hours
Lamp usage time exceeded
Order a new lamp at lamp.benq.com
OK
Out of Lamp Usage Time
Replace lamp (refer to User Manual)
Then reset lamp timer
Order a new lamp at lamp.benq.com
WARNING