Black Box ACX1000 Electronic Accessory User Manual


  Open as PDF
of 2
 
724-746-5500 | blackbox.com724-746-5500 | blackbox.com 724-746-5500 | blackbox.com
ACX1000 Quick Start Guide ACX1000 Quick Start GuideACX1000 Quick Start Guide
Page 3Page 2 Page 4
1. Quick Setup
This section briefly describes how to install your Repeater
or Cross Repeater. Unless you are an experienced user, we
recommend that you follow the procedures described in the
rest of this guide.
2.2 System Setup
To install your Repeater/Cross Repeater:
1. Switch off all devices.
2. Connect the interconnect cable to the local device’s
interconnect socket and the repeater/cross repeater.
3. Connect the interconnect cable to the remote device’s
interconnect socket and the repeater/cross repeater.
4. Connect the 5-VDC power supply to the repeater.
NOTE: Use only the power supply that you received with this
unit or a manufacturer-approved replacement.
3. Hardware Description
3.1 Device Views
Figure 1. Repeater/cross repeater CATx view.
Figure 2. Repeater/cross repeater fiber view.
3.2 Diagnostics
Each repeater/cross repeater has three LED indicators:
Power, Data Error, and Link Status. The Power LED is next to
the power socket.
Figure 3. Diagnostic LEDs on the repeater/
cross repeater.
Table 1. LED indicators and their functions.
LED Setting Description
Power (red) Off Device not ready
On Device ready
Link Status Blinking No interconnect
(green) connection via CATx
or fiber cable
On Device ready
Data Error (green) Not used
4. Service Setup
For most applications, you won’t need to make any
adjustments to set up your repeater/cross repeater.
For some applications, you may need to open the repeater.
Unscrew the UNC-type screws on both sides of the monitor
connections. Put the lower and upper shells of the case
aside.
Figure 4. Removing the screws.
2. Installation
For first-time users, we recommend that you carry out a test
placement, confined to a single room, before installing it
fully. This will enable you to identify and solve any cabling
problems, and experiment with the Repeater/Cross Repeater
more conveniently.
2.1 What’s Included
Your package should include the following items. If anything
is missing or damaged, contact Black Box Technical Support
at 724-746-5500 or info@blackbox.com.
• Repeater/Cross Repeater
• 5-VDC universal power supply
• U.S. power cord
• This Quick Start Guide
 previous