Filter
Top Products
12
USB SINGLE-PORT HUB (RS-422/485)
Since you have already installed the software by running
“Setup,” simply click “Next” to proceed. The drivers that
were installed during setup will automatically be used to
configure the adapter.
Figure 3-3. Hardware installation finished screen.
Windows has now located a driver and installed the
software. Click “Finish” to proceed. You should see one
more “New Hardware Found,” indicating the actual port
being created. If you view your system’s Device Manager
at this point, you should have a new “COM” port in the
Ports (COM & LPT) Device Class. It should look similar
to the illustration on the next page.
Add New Hardware Wizard
<
Back Finish Cancel
USB Single-Port Hub
Windows has finished installing the new hardware device.