![](http://pdfasset.owneriq.net/c/91/c91be9e3-1751-44cc-915d-e6348d85b238/c91be9e3-1751-44cc-915d-e6348d85b238-bgb4.png)
Page 180
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Port Authentication
Authentication State:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use dot1x reauthetication command to enable reauthentication on a port.
Use no dot1x reauthetication command to disable reauthentication on a port.
3. Command Syntax:
(no) dot1x reauthentication
4. Example:
The following example specifies to enable reauthentication on the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#dot1x reauthentication
switch_a(config-if)#
Port Control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#