Filter
Top Products
Black Box LR11xx Series Router Configurations Guide
76
10.4.2 Static NAT (one to one)
Figure 20 Static NAT
In static (one-to-one) NAT type, for each IP address in the corporate network, one NAT IP address will be used. For example,
for the three IP addresses from 10.1.1.1 to 10.1.1.3, there is a set of three NAT IP address from 50.1.1.1 to 50.1.1.3. In case of
one-to-one NAT, only IP address translation takes place, that is, if a packet travels from 10.1.1.1 to yahoo.com, the Black
Box-Firewall only substitutes the source address in the IP header with the NAT IP address. The source port will be the same as
the original.
The static NAT configuration shown in Figure 20 includes:
Private network address:10.1.1.1—10.1.1.3
Public (NAT) IP address range: 50.1.1.1—50.1.1.3
To create NAT pool with type static, specify the IP address and the ending NAT IP address. Add a policy with source IP
address range and attach NAT pool to the policy.
50.1.1.1-50.1.1.3
OPAL
10.1.1.3
10.1.1.2
10.1.1.1
INTERNET
Blackbox/configure> firewall corp
Blackbox/configure/firewall corp object
Blackbox/configure/firewall corp/object> nat-pool addresspoolStat
static 50.1.1.1 50.1.1.3
Blackbox/configure/firewall corp/object> exit
Blackbox/configure/firewall corp> policy 7 out address 10.1.1.1
10.1.1.3 any any
Blackbox/configure/firewall corp/policy 7 out> apply-object
nat-pool addresspoolStat
Blackbox/configure/firewall corp/policy 7 out> exit 2
Blackbox/configure>