Filter
Top Products
Page 8
724-746-5500 | blackbox.com
Chapter 4: Configuration and Setup
4.0 Configuration and Setup
Remove and discard all packaging materials. Open and inspect the LTD or LTDB to
verify all doors, drawers, and locks are working properly.
For the LTDB, lock the casters prior to setting up, loading, or unloading laptop
computers to prevent the LTDB from moving.
Feed the power strip cord through the grommet hole located on the side of the LTD.
Do not plug the LTD into the wall outlet until all configurations and setup are
complete.
Attach power bricks to the dividers to create separate slots for the laptop computers.
4.1 Installing Power Bricks on the Dividers
Remove a divider to install a power brick on it. Follow these steps to install the power
bricks on each divider:
Step 1. Lay the divider flat on the work surface. Lay a laptop computer and a power
brick on top of the divider, with the computer end of the power wire toward the top
of the divider. Plug the power brick into the laptop computer. Lay the wire across the
two holes at the top of the divider. Make sure that there is some slack between the
front hole and the plug.
Make sure there
is slack at these
two points
Netbook
Cord slack
Note this point
Power Brick
Align the back of the notebook
with the back of the divider
Figure 4-1. How to thread the electrical cable through the dividers.
LTD5