Filter
Top Products
25
CHAPTER 5: Utility Software
5.2 GETW95C Program
The GETW95C.EXE program is provided on the Utility diskette to allow the
operator to get configuration information and will display the resources assigned
to the Adapter by Windows 95/98. The CEM5250.VXD driver must have been
installed prior to executing this program. The CEM5250.VXD driver is normally
installed automatically by Windows 95/98 when the Adapter Card is first installed
in the system.
GETW95C is a DOS program for Windows 95/98 and can be executed by selecting
the Start icon, then Run. Enter the following at the prompt and then select OK.
The following example assumes the default installation directory (5250CARD).
C:\5250CARD\GETW95C
A DOS window will be opened and the program will execute showing the results.
The following example shows the results of executing the GETW95C program. The
values for the Memory Segment, I/O Port, and IRQ fields will contain the
information passed by Windows 95/98. The values in this example may not be the
same as observed on your system.
NOTE
If the “Memory Segment” or “V86 Memory Segment” indicates 0000, you
have a memory conflict and should refer to Appendix A.
Get W95 Configuration
Version 2.05
The VxD Version is 2.03.
Adapter type is 5250 PCI.
Memory Segment is DC00.
V86 Memory Segment is DC00.
Memory Size is 0x2000 bytes.
I/O Port is 118.
IRQ is 12.