Filter
Top Products
BLADEOS 6.3 Application Guide
BMD00178, April 2010 29
Static Mrouter
If a port has a static multicast router (Mrouter) configured, and you move the port to a different
VLAN, the static Mrouter appears in the /info/l3/igmp/mrouter/dump output for the
original VLAN.
Solution: When you move the port to a new VLAN, remove the static Mrouter from the port, and
add it again.
QoS Metering
Traffic may exceed the configured maximum burst size of the ACL meter
(/cfg/port <x>/aclqos/meter/mbsize) by one packet, with that packet remaining
In-Profile. Once the ACL meter has been exceeded, additional burst packets fall Out-of-Profile.
QoS and Trunking
When you assign an ACL (or ACL Group) to one port in a trunk, BLADEOS does not automatically
assign the ACL to other ports in the trunk, and it does not prompt you to assign the ACL to other
ports in the trunk.
Solution: Manually assign each ACL or ACL Group to all ports in a trunk.
RADIUS with SSHv2
With RADIUS turned on, users might see a duplicate login prompt for SSHv2 clients, if the
RADIUS server is too slow to respond or if the RADIUS server is not available. In this case, users
must re-type the username and password to login.
RIP MIBs
Due to backward-compatibility issues, two Routing Information Protocol (RIP) MIBs are available
in BLADEOS: ripCfg and rip2Cfg. Use the rip2Cfg MIB to configure RIPv1 and RIPv2
through SNMP.
BLADEOS does not support the standard RIPv2 MIB as described in RFC 1724. Use the rip2Cfg
MIB to configure RIPv1 and RIPv2 through SNMP.