Filter
Top Products
en | 7
Bosch Security Systems | 2005-04 | 9922 141 70164en
2.2 Configuration
Before using the Integrus audio input and interpreters
module, the operation mode must be chosen by setting
the DIL function switches on the module’s circuit
board:
• Select the mode in which the module must operate:
1. As an interface to one or more LBB 3222/04
interpreters desks.
2. As an interface to other audio sources.
• Select if floor distribution (see section 1.6) should
be enabled.
1. Enable floor distribution when LBB 3222/04
interpreters desks are directly connected
2. Disable floor distribution when LBB 3222/04
interpreters desks are connected via a CCS 400
system.
• Select the channels on which the module’s signals
will be distributed.
The table below lists all the settings.
INTEGRUS | Installation and User Instructions | Integrus audio input and interpreters module
DIL Switch Function On Off
I 1,2,3,4,5,6,7,8 Interpretation Direct connection to Connection to
LBB 3222/04 interpreters desks other audio sources
II 1,2,3,4,5,6,7,8 Interpretation Direct connection to Connection to
LBB 3222/04 interpreters desks other audio sources
III 1,2,3 Interpretation Direct connection to Connection to
LBB 3222/04 interpreters desks other audio sources
III 4 Floor distribution Disabled Enabled
III 5 Channel selection Channels 8-15 Channels 0-7
III 6,7,8 Not used
Notes:
• If floor distribution is enabled (DIL
switch III-4 off), the floor audio signal
will be distributed on those channels
where the interpretation microphone is
switched off.
• When interfacing between more than
one LBB 3222/04 interpreter desk and
the infra-red system, or interfacing
between the CCS 400 power supply
and the infra-red system, the floor
distribution should be disabled
(DIL switch III-4 on).
• Do not use a CCS 400 power supply in
combination with direct connection to
LBB 3222/04 interpreter desks, as this
will cause a fuse to blow.
• When the Integrus audio input and
interpreters module is used in
combination with audio signals
connected to the cinch inputs of the
Integrus transmitter, the signals on
corresponding channels are mixed.
• Check the positions of the
DIL-switches before mounting the
LBB 3422/20 Integrus audio input
and interpreters module in an
Integrus transmitter.