Power Supply Installation | en 13
Bosch Security Systems Installation manual AR18-10-B002 | v1.1 | 2011.10
2 Installation
2.1 Tools required
– Small flat blade screwdriver.
– Crosshead screwdriver.
– Wire cutter/stripper tool.
2.2 Opening the side covers
Figure 2.1 Removing side covers
Unscrew the four cross-head screws at each corner and remove
each of the side covers.
2.3 Mount the unit
Figure 2.2 Mounting the unit
Secure the unit to a flat surface using mounting screws (not
supplied) in the four holes (4 mm) shown in the figure.
CAUTION!
Installation should only be performed by qualified service
personnel in accordance with the National Electrical Code or
applicable local codes.
Disconnect the supply power before installing