Filter
Top Products
General Purpose LCD Monitors Installing the Monitor | en 15
Bosch Security Systems, Inc. User’s Manual F.01U.127.338 | 2.0 | 2009.05
2. Mount the unit to the mounting device (not provided) using the four (4) mounting holes
on the rear panel. The square mounting hole patterns are standard on 100 mm (3.9 in.)
centers. Four (4) M4 x 10 mm screws are required and are provided with the Bosch
mounting kit.
Figure 6.2 Mounting the Device
6.3 Connecting the Composite Video Signal to the Monitor
There are two (2) BNC connectors located on the rear of the monitor for composite video
input and two (2) BNC connectors for composite video outputs (see Figure 3.2).
NOTE: All video inputs are passive loop-through. The impedance is automatically set to 75
ohm by the input of the signal on the input connector, while operating in a single connection
mode (see Figure 6.5). If a cable is also connected to the output connector, the video signal
can be passed on to another monitor connected to it via the passive loop-through function. Up
to three (3) looping monitors may be connected in this manner (see Figure 6.6).
i
NOTICE! To select between AV1 and AV2, press Input (Figure 3.1, Item 1) located on the front
of the monitor