Filter
Top Products
AutoDome Power Supply Boxes Cable and Wire Standards | en 37
Bosch Security Systems, Inc. Installation Guide F.01U.250.895 | 1.0 | 2011.08
Audio Connections
1. Remove the 100 Ω termination resistor from the Biphase
terminals.
2. Connect the audio line level source to the Biphase C+ input
terminal.
3. Connect the audio signal ground to the Biphase C- input
terminal.
The following figure illustrates the connections for audio
over an IP network.
Figure 3.10 Connections for audio over an Ethernet network
1 C- (Biphase) 7 AutoDome Data In/Out
2 C+ (Biphase) 8 P105/P106 Connector
3 Earth Ground 9 Audio Out
4RxD
5TxD
6 Signal Ground
NOTICE!
Refer to the VG5 700 Series AutoDome User Manual for
configuring and using audio over an IP Ethernet network.