Filter
Top Products
24 Printer-Applicator-System PAM 3000
Blow Tube
It is necessary to mount a blow tube when applying large labels. This way the label is additio-
nal blown against the pad with an air current coming from the blow tube. The air current
supports the take-over of the label by the pad.
There is an equipment (1) at the front side of the printer to attach the blow tube.
Fig. 5h Installing the blow tube
1
32
1. Screw the blow tube into the equipment (1) on the front side of the printer.
2. Turn the drillings of the tube (3) to the dispense edge of the printer.
3. Hold the slotted screw (4) with a screwdriver and fix the tube by tightening the counter
nut (2).
4. Slide the DIP-switch 4 on the side of the printer to the position "OFF" (see page 34).
4