Filter
Top Products
89
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
The printer was
unable to complete
the Media
Calibration; or, the
printer was
powered off or
reset during a
ribbon, out of stock
or TOF fault.
Press the FEED key in an
attempt to clear the message.
If necessary, perform a media
calibration or correct the
related fault condition.
The printer has
detected a problem
within the print
logic.
Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
The system has
detected a RAM
failure.
Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
Consistently low
sensor readings
were detected.
Press any key to continue.
Ensure that the reflective
mark was inserted facedown
in the media sensor during
the appropriate calibration
step; also, ensure that the
reflective mark is made of
carbon based ink, and that the
sensor is free of debris. Retry
calibration. If the problem
persists, try an ‘Advanced
Entry Calibration’; see
Section 5.0.2.