Brother 1800 Network Card User Manual


 
78
CAN’T
HERE!
This message appears if
the cursor is at the end of
the text when you hold
down and press
.
Move the cursor below a
number before holding
down and press-
ing .
CHANGE
ADAPTOR
This message appears if a
high-voltage adaptor is
being used.
Remove the high-voltage
adaptor and connect the
adaptor designed exclu-
sively for this machine.
CUTTER
ERROR!
This message appears if
the tape cutter lever is
pressed down while a
label is being printed.
Release the tape cutter
lever.
INVAL.
CHRS!
This message appears if
the cursor is not below a
number when you hold
down and press
.
Move the cursor below a
number before holding
down and press
.
LENGTH
LIMIT!
This message appears if the
text is longer than 1 meter
when you try to print.
• Shorten the text to less
than 1 meter before trying
to print.
This message appears if
the Length function is
used to set a label length
that is less than 1.6” (4.0
cm) or more than 11.8”
(30.0 cm).
Set the label length
between 1.6” (4.0 cm)
and 11.8” (30.0 cm).
This message appears if
the Tab Length function is
used to set a tab length
that is more than 11.8”
(30.0 cm).
Set the tab length so that
it is less than 11.8” (30.0
cm).
Error Message Cause Remedy
Number
Number
Number
Number